PROJECTS GALLERY


Floating Shelf

We were asked to make a floating shelf for a powder room. The shelf needed to match the flooring and the wall cladding that would be on the wall behind the shelf. Because the finish would be a very difficult match, we decided to try to make the shelf out […]

shelf

Custom-3D-CNC-wakeskate-core-Fort-Lauderdale-Florida

Custom Wakeskate

A local competitor asked us to carve a custom wakeskate for him as a prototype for a new design. To keep the cost down we built a blank out of 2×4’s.   The roughing pass removed an enormous amount of material. We used a 1/2″ endmill at a depth of […]


Angled Bases for Davits

Northern Star Boat Works was installing a set of dinghy davits on a customers sailboat. The sailboat manufacturer was able to supply factory bases for the davits, but they were only a shell and were flat on the bottom. Because they were flat and the deck has a camber they […]

davit-bases-ready-to-be-skimmed-by-the-CNC-machine

Custom Panel

Custom Instrument Panel

We fabricate a lot of custom panels for the local yachts. New panels are needed whenever the electronics or instruments are updated. We fabricate panels out of composite materials, fiberglass, acrylic and wood depending on the needs of the customer. We can custom design your panel, or work from existing panels […]


CNC-milled-louvered-door-stile

Louver Stiles

The easiest way to build louver doors is to use a set of stiles cut for the louvers. Here is a look at a stile that we just cut for a customer. Contact us for custom stiles.        


Custom Guitar

Rudy Delgado from AVE Guitars stopped by to check out our operation, and to see if we could help him build custom guitars. Rudy is in the prototyping stage of his new guitar. These are some of the parts that we have cut in an effort to make his design […]

Body

Custom TV Bezel

Each flat screen installation presents it’s own challenges. This particular install was difficult for the carpenter because the television had rounded corners and the owner wanted the smallest gap possible around the television itself. With careful measurements and programming we were able to cut a bezel that matched the shape […]